Next: Routing through a Gateway Up: Interface Configuration for IP Previous: The Loopback Interface . Configuring an Ethernet interface goes pretty much the same as with the loopback interface, it just requires a few more parameters when you are using sub-netting. ... To make the interface recognize this, the ifconfig incantation would look like this: # ifconfig eth0 vstout netmask 255.255.255.0 This assigns the eth0 interface the IP-address of vstout (191.72.1.2). ...
... The directives provided by mod_access are used in <Directory> , <Files> , and <Location> sections as well as .htaccess files to control access to particular parts of the server. ... The Allow and Deny directives are used to specify which clients are or are not allowed access to the server, while the Order directive sets the default access state, and configures how the Allow and Deny directives interact with each other. ... The Allow directive affects which hosts can access an area of the server. ...
... Эта глава познакомит вас с некоторыми из наиболее интересных возможностей Linux. ... IP адрес. ... Администратор вашей сети скажет адрес вашего сервера имен. ... Dip можно также использовать для настройки вашей системы Linux в качестве SLIP-сервера, когда другие машины к вам дозваниваются и выходят в сеть через вторичное соединение по Ethernet на вашей машине. ... Если вы используете SLIP-сервер, выдающий статические IP адреса, вы можете включить записи о ваших IP адресе и хост-имени в /etc/hosts . ...
... USER PREFERENCES . ... SpamAssassin is configured using traditional UNIX-style configuration files, loaded from the /usr/share/spamassassin and /etc/mail/spamassassin directories. ... Set the score required before a mail is considered spam. n.nn can be an integer or a real number. 5.0 is the default setting, and is quite aggressive; it would be suitable for a single-user setup, but if you're an ISP installing SpamAssassin, you should probably set the default to be more conservative, like 8.0 or 10.0...
Для каждого узла сети Химического факультета в базе данных обязательно должен быть указан MAC-адрес сетевого адаптера. ... Согласно стандартам на сеть Ethernet, не может быть двух сетевых адаптеров с одинаковым MAC-адресом. ... Запустите окно командной строки и выполните команду . ... Определить MAC-адрес компьютера, работающего в сети, можно и дистанционно, с другого компьютера. Допустим, Вы хотите определить MAC-адрес компьютера с IP-адресом target , работая на компьютере с IP-адресом source . ...