... WF/PC-1 keywords include items such as observing mode, integration time, and filters used, calibration steps performed and reference files used, and the properties of the data itself (e.g., number of groups, coordinates, scale, flux units, image statistics, and more). ... GENERIC/BIAS/DARK/PREF/FLAT/MASK/ATOD/NO Is the image a reference file and if yes, type is specified . ... First filter name . ... Engineering file data quality file (DQF) name . ... Name of the bias frame reference file . ...

... Exposure Time Calculator (ETC) . ... ESO - Public Surveys . ... the recommended values to use for DIT, . ... Detector on-chip integration (DIT): seconds. to your chosen value - a separate page gives recommended values to use for DIT - for modes 1 and 2 below you may wish to start with the maximum recommended values as these will minimize the effect of read noise (a total object exposure of Y secs with DIT=X secs will produce Y/X lots of read noise) and give you a lower limit on the time needed. ...

... Science Users Information > Observing with ESO Telescopes > Phase 2 Preparation > Observing conditions . ... Service Mode Philosophy . ... The following definitions of the observing conditions are common between Phase 1 preparation and Phase 2 preparation, as well as between Service Mode and Visitor Mode observations. ... There are additional Service Mode Policies and Service Mode Guidelines regarding the observing conditions. ... Seeing (Phase 1) and Image quality (Phase2) constraints . ... Moon . ...

... Initial Setup Tasks . ... IFP#1-LO 6641 - 6657 MHz USB RCP . ... IFP#1-HI 6657 - 6673 MHz USB RCP . ... IFP#2-LO 6641 - 6657 MHz USB LCP . ... IFP#2-HI 6657 - 6673 MHz USB LCP . ... IFP#1-LO 6300 - 6316 MHz USB LCP . ... IFP#1-HI 6316 - 6332 MHz USB LCP . ... Ftp: ftp://ftp.atnf.csiro.au/pub/people/vlbi/v255/v255a . ... The 4 x 16 MHz bandpass setup will require feeding two separate LOs into IFP#1 and #2 on the DAS/frequency translator and splitting the LCP signal so that is feed into both sides. ...

About us . ... Telescopes . ... Apart from the 6-meter telescope BTA two small telescopes are operative at SAO: the 1-m and 0.6-m telescopes, both manufactured by Carl Zeiss, Jena, are located near the BTA. ... These telescopes are used for adjusting the equipment and techniques of observations used at the BTA. ... The observational time allocation and also a brief description of the equipment of the 1-m telescope, which is used either permanently or mainly on this telescope, are presented below. ...

... NGC 1530 is one of the largest barred spiral galaxies in the northern sky, with bright CO emission. ... To trace molecular gas, we observed the line, with the IRAM Interferometer. ... Properties of NGC 1530 and observational results . ... Then in a frame rotating with the potential, the periodic orbits are ellipses either parallel to the bar ( ) or perpendicular ( ), depending on the radius of the orbit. ... We observed the molecular gas in the bar of NGC 1530, a barred SBb spiral in the line. ...

... 1) Our CAS system will store the catalogues. ... Each catalogue should contain one or more tables. 2) The names of the catalogues should be unique, as well as the the names of tables of the SAME catalogue. ... 4) All the metadata about the CAS system, its tables, catalogues should reside in separate schema (currently "cas_metadata"). 1) The main system table of CAS is the table "catalog_list". ... short info (column "info") . ... 2) The second system table of CAS is the table "table_list". ...