... FGS Data Handbook . ... Fine Guidance SensorData Handbook > Chapter 5: Astrometric Error Sources > 5.3 Visit-Level Position Mode Errors . ... 5.3.2 Drift Correction Errors . ... Astrometry with the FGS, by contrast, proceeds in the reverse order; the positions of the individual objects are found first, and then a virtual plate is constructed with the help of data from the guide stars and check stars. ... Such motions can be detected and eliminated using guide star data and check star measurements. ...

Position Switching Separation Tolerance with Arecibo in L-Band Travis McIntyre The University of New Mexico July 2010 Revised December 2013 Abstract The blocked telescope aperture at Arecibo creates standing waves in the bandpass around 1MHz. ... Test observations with Arecibo in L-Band show that position switching effectively removes standing waves for separations of one half FWHM or less. Standing waves remain for separations of one FWHM, increasing the rms of the baseline by 20%. ...

Next: Catalog Construction Up: Observations and Analysis Previous: Source Detections . ... It was assumed that the highest signal gives the most likely position of the source. ... Comparing the summed map with the maps from the individual energy ranges, the one which produced the smallest error box was chosen to represent the source position, as long as was greater than 4, a level chosen to reflect a reasonable degree of confidence in the detection. ...

... These steps must be run on the qpoe file before the dewobble scripts are implemented. ... This is because the phase of the wobble is fixed to the space craft clock. c) Create an ASCII file with the listed obi start and end times. ... The IRAF script 'phase_repos' breaks up each obi of the qpoe file into a number of phase bins. Then a source centroid is calculated for each binned qpoe file. ... Each binned qpoe file is labelled by two indices, the obi and the phase number. ... Run phase_repos: . ...

The close position of main satellite and subsatellite (distance between them about 1000 km) and using the similar sets of Faraday cups (VDP and VDP-S) with high resolution measurements (up to 16 Hz for the main satellite and up to 10 Hz for the subsatellite) allow us to determine the small-scale variations of the magnetopause shape and position and to estimate the velocity of the magnetopause motion. ... Two point observation of the magnetopause motion: the INTERBALL project. ...

... The HST uses an onboard model of its orbit to perform in real-time various control functions relating to spacecraft operations and observation support. ... New coefficients for the ephemeris are updated every other day, and are archived as FITS keywords for each HST observation data set. Using these coefficients,an observer can perform a variety of calibration and characterization calculations relating to the orbital position and velocity of the telescope. ...

... region (region-6.2.2) [xmmsas_20030110_1802-5.4.1] . ... The region task will automatically determine the optimal source and background extraction regions for a detected source in an XMM observation. ... The regions are defined in sky coordinates. region will attempt to maximise the area of the extraction region for each source, whilst ensuring that the extraction regions of neighbouring sources do not overlap, and that the background extraction region for a given source excludes neighbouring...

In the Table below the masses of some asteroids which were determined during the last years are listed. ... The listed values were determined from observations of many test bodies by the weighted least square fit for one perturbing mass and corrections to the orbit elements of all used test bodies. ... based on the observations of 98 asteroids (including 50278) with the values of standard error of mass determination less than 3.0 10 -11 M Sun . ... Mass . ... 3) Mass 121 : 0.74 x 10 -11 M Sun ; . ...

... To plot the data (and model, here xitau.model), I have read the model, computed the model values for the ASTROMETRY, and used Plot|ASTROMETRY to produce the ASTROMETRY plot widget. ... First, plot the data and with Util|Ellipse and the mouse buttons interactively define an apparent ellipse to fit your data as best as you can. ... Under Util|Orbit, there is a Thiele-Innes procedure to estimate the orbital elements using your apparent ellipse and Kepler's laws! ... Back to tour page . ...

Prognoz-7 satellites magnetometer observation database . The Prognoz-7 satellite was launched 30 October 1978 into orbit with perigee 500 and apogee 203000 km, orbital period was 98 hours. Magnetic field measurements were conducted by SG-70 magnetometer with working range +/- 60 nT., accuracy about 0.3 nT. and sampling rate 1 measurement per 10.24 sec. Magnetic measurements and satellite position data in GSE coordinate system are presented in separate ASCII files. ...

The Australia Telescope Compact Array (ATCA) . Home page Team Galaxy Sample Observations Papers Projects Related Surveys Pipeline Meetings . Local Volume galaxies ( B. Koribalski) . The Local Volume HI Survey'' (LVHIS) is a project comprising deep HI line and 20-cm radio continuum observations for all nearby, gas-rich galaxies, supplemented by multi-wavelength data. ... Our aim is to study the formation and evolution of galaxies in the Local Universe. ...

Computer Ephemeris for 2015 from DE200/LE200. Longitude of central meridian of Uranus. ...