Next: Photometric Corrections Up: Long-Slit and 1D Previous: Long-Slit and 1D . This chapter describes the long-slit љ reduction package in a general way. ... The package provides about 50 basic commands to perform the calibration and to display the results, defined in the context LONG . ... The context SPEC is a low-level context including general utility commands required by the different spectroscopy packages ECHELLE , IRSPEC and LONG . ... This interface is described in the Appendix . ...

... Science . ... Science Users Information > Observing Facilities > Instrumentation Development > VLT/Instrument Interfaces . ... APEX Visitor Instrument . ... The interfaces between the VLT Unit Telescopes and the scientific instruments to be operated at the VLT Cassegrain, Nasmyth and Coudц© foci are well defined. ... Interface and numerous other relevant information for instrument builders is available in the "Requirements for Scientific Instruments on the VLT Unit Telescopes" , ESO doc. no. ...

... Charge Coupled Devices (CCD) are currently by far the most widely used type of detector in astronomy. ... After a brief introduction to the VLT Control System, the VLT CCD Detectors Control Software is presented. The VLT Control System is a distributed system consisting of a set of UNIX Workstations, dedicated to high level operations, such as coordination of sub-system activities and interface to the users, and VME-based Local Control Units (LCU), dedicated to the control of sub-systems hardware. ...

... To be read in conjunction with Section 7.6 of the WFPC2 Instrument Handbook , Version 4.0 Dithering is the act of displacing the telescope between observations either on integral pixel scales (to assist in removing chip blemishes such as hot pixels) or on sub-pixel scales (to improve final image resolution). ... In particular, at the time of the last writing, our experience in removing cosmic rays from singly dithered data (i.e., only one image per pointing) was quite limited. ...

... IRAF View . This is the orientation of the image as viewed in an image display via IRAF (e.g. ximtool, saoimage). Note: This is different from the orientation of the image as viewed on a Macintosh, via Remark . ... A +X, +Y instrument offset will move a star in the direction indicated by the arrows. ... Note: The offset direction depends upon which interface the offset command was issued in! ... Note: This is different from the orientation of the image as viewed by IRAF. ...

Simulations for ALMA: Discussion points Robert Laing European Instrument Scientist Simulations for ALMA IRAM, Sept 8 -11 2008 Issues for the user What simulations are needed to help (inexperienced) users? ... What can we do to promote collaboration ALMA 3 Robert Laing European Instrument Scientist Simulations for ALMA Technical Issues Voltage patterns Critical for I and polarization Start with EM simulations; then use measurements Can we do better than MEM / multiscale clean? ...

... The only event-driven pieces of software were the user interface Hermes, the display server GIDS and the GDS server. ... Event-driven tasks are fundamentally different from procedural tasks. ... Using this event handling, a collection of routines has been built, which allows the programmer to construct a graphical user interface for a task. ... These are the events associated with user input keywords and one other event which is generated when a task is resumed after it was pausing. ...

Next: CCD Operation Up: Charge Coupled Devices (CCDs) Previous: Charge Coupled Devices (CCDs) . ... However it is only now that a number of important X-ray astronomical applications of CCDs have reached critical development stages, so that this is an appropriate time to review the application of space-borne CCD instruments to cosmic X-ray astronomy, and highlight the particular concerns which are being addressed for X-ray instruments, as distinct from optical applications. ...

Distributed Software for Observations in Near Infrared V. Gavryusev 1 and C. Baffa Osservatorio Astrofisico di Arcetri E. Giani Dipartamento di Astronomia, Universit`a di Firenze Abstract. ... The processes denoted for control of hardware (telescope and other instruments) should be executed currently on PC dedicated for this task under DESQview/X, while all other components (user interface, tools for the data analysis, etc.) can work also under Unix. ... 1993, Di Giacomo et al. 1993). ...

... Created: 23 February 2001 . ... SOFTWARE MAINTENANCE MANUAL . ... 9 January 2001 . ... Note: in the final document, the table of contents will be to third level] . The Software Maintenance Manual describes the procedures for installation and maintenance of the software for the Gemini Near-infrared Integral Field Spectrograph (NIFS). ... Section 19.4.3 of the document “Programmatic Requirements for Gemini Instrumentation Development” states the requirements for the Software Maintenance Manual . ...

Magnetic field measurements onboard the Interball Tail spacecraft are carried out by the FM-3I instrument which consists of two flux-gate magnetometers covering two different ranges: [-200, +200] nT and [-1000, +1000] nT. Besides scientific goals, the FM-3I experiment data is used to perform the attitude control of the Interball Tail spacecraft. ... August 22, 1995 . ... October 18, 1995 . Top of the page . ... Back to the Interball Home Page . ...