... The keywords EXPRTIME and ZEROMAGN set the zero point for magnitudes. ... The program automatically determines a Point Spread Function when it gets proper initial values from the keywords SPROFIL. Initial values may be wrong by 0.1 each, and the program still can converge to the right Point Spread Function. ... The program looks for an initial point spread function into that descriptor at first and it uses data from the keywords SPROFILx when the descriptor DPROFILE is absent. ...

Еще в разделе: (Показать все результаты (>1377) - www.sao.ru/ )

... When Snapshot visits are ready to be placed on a flight calendar, they are added to the snapshot Pool automatically. The method for selecting a visit in the Pool is an "ordered" random sample of candidates within six categories ordered by Cycle number (higher to lower) and percentage of visits that have been scheduled or completed. A proposal that has less than 50% of its visits scheduled or completed is given preference within a cycle. ... Cycle N proposals with a completion percentage <50%. ...

Еще в разделе: (Показать все результаты (>9163) - www.stsci.edu/ )

... NEWS . For every new DFS component delivery, following process should be applied. ... The appropriate DFS installation scripts must be included in the package delivered to the mountain (install-patch if a patch is delivered, ipip if a new pipeline release is to be installed, .. ... The Delivery Note is the text file to be sent to the mountain by email giving all detailed information about the new DFS patch or release, plus the specific installation instructions to be applied by the mountain. ...

Еще в разделе: (Показать все результаты (>41476) - www.eso.org/ )

• Reduce visibility data
• the Technical Archive procedure for issue of documentation
• Allocate/load STARTABLE

... Before you calibrate, you must prepare your data. This consists of loading, flagging, perhaps converting to ``channel-0'' datasets, and then splitting. ... Tracking accuracy: the tracking accuracy of the ATCA antenna is usually adequate at low frequencies, but at higher frequencies (where the primary beam is smaller), tracking errors become more deleterious. ... In addition, poor tuning of the antenna drive systems can sometimes cause poor tracking, particularly after a source change. ...

Еще в разделе: (Показать все результаты (>6576) - www.atnf.csiro.au/ )

• VLBI Wiki | Main / ProducingSchedules
• lbaops:producingschedules [ATNF VLBI Wiki]
• Language Extensions

An example of visual expert system. The program is written on Actor Prolog. -- -- (c) Alexei A. Morozov, March 19, 1999. ... Actually I wrote this program to train myself -- -- in carrying out SADT interview. ... A logical description of the blocks of the SADT model. ... The main purpose of these classes is keeping lists of cooking -- -- battery corresponding to various blocks of the SADT model. ...

Еще в разделе: (Показать все результаты (>453) - www.cplire.ru/ )

• Getting Started in Actor Prolog. Oil Production.
• EIT Server Input File Format
• Actor Prolog User Guide. SADT.

Arecibo telescope proposal deadlines now fall on (or about) March 1 and September 1 each year. ... Proposals should be prepared under the revised procedures detailed in . ... We invite proposals for the use of the Arecibo 305-m telescope for the September 4, 2012 (17 EST), deadline. ... Technical information for Arecibo proposers . The (revised) web-form coversheet for proposals can be found at . ... Remember to also separately email a PDF of the main body of your proposal to proposal@naic.edu. ...

Еще в разделе: (Показать все результаты (>1416) - www.naic.edu/ )

• Arecibo Call for Proposals: Thursday, March 3, 2016 Deadline
• Calibration Scans
• Calibration Scans on Continuum Sources

... In Figures 2-2, 2-3, 2-4 spot diagrams corresponding to the minimum dispersion configuration at zenith, maximum dispersion at 60° and ADC compensation at 60° are shown. ... Date:04.06.98 Page 2 of 6 Figure.2-1 Camera and ADC with curved surfaces in the maximum dispersion configuration Figure.2-2 Spot corresponding to the configuration of minimum dispersion at zenith 2 Document : VST_040698_optic.doc Release :1 First rel.date: 04.06.98 Last rel. ... Date:04.06.98 Page 5 of 6 Figure. ...

Еще в разделе: (Показать все результаты (>6286) - www.arcetri.astro.it/ )

• Radioastronomy reduction procedures
• Using Apache With RPM Based Systems (Redhat / CentOS / Fedora) - Apache HTTP

XMM-Newton Science Analysis System . ... A different approach is done via the setting withctisrcpos =Y: all event energy corrections do not use the actual RAWY coordinate but the corresponding RAWY location of the source ( SRCPOS ) as determined by the task epframes (either automatically or via setting withsrccoords =Y). ... The task epchain may be used with the setting ccds =4 withctisrcpos =Y to process only the CCD 4 where usually the bright source is located that causes the Out-of-Time events. ...

Еще в разделе: (Показать все результаты (>5225) - xmm.vilspa.esa.es/ )

Procedure to Plug a Plate . ... Procedure . ... Data cartridge ; Location : stored on racks inside elevator bay, plugging station, or mapping station; Appearance : approx 4.5' dia X 3' thick., fiber optic wire interior, plate top, protected sides, top, and bottom; nine total; 400 lbs. each. ... Each plate is marked in groups of twenty holes; the fiber optic wires are in bundles of twenty wires. ... An additional eleven guide fiber optic wires (marked with black tape around wire) must be plugged. ...

Еще в разделе: (Показать все результаты (>447) - www.apo.nmsu.edu/ )

• SDSS M1 Mechanical Collimation
• Procedure to Remove 2.5m Wind Baffle
• Procedure to Install the 2.5m Secondary Truss

... Created: 22 January 2001 . ... SERVICE AND CALIBRATION MANUAL . ... Draft Document Outline. ... 4 Preparing NIFS for Use or Storage . ... The purpose of this Service and Calibration Manual is describe the procedures used to service, maintain, and calibrate the operation of the Gemini Near-infrared Integral Field Spectrograph. ... Section 19.4.2 of the document “Programmatic Requirements for Gemini Instrumentation Development” states the requirements for the Service and Calibration Manual . ...

Еще в разделе: (Показать все результаты (>342) - www.mso.anu.edu.au/ )

• Preparing to lift the chimney.
• Preparing to erect the Polar Axis, early 1953
• Preparing to lift the polar axis of the 50"

Next: Electronic colophon Up: Contents Previous: Data Modeling and Analysis . These Proceedings were prepared as a single LaTeX document, using a style based on the PASP conference style. ... There are 119 figures, for which we received 130 Encapsulated PostScript (EPS) files and only eight figures on paper. ... We scanned the eight printed figures (and the conference photograph), so that all of the figures would be available in the electronic version. ...

Еще в разделе: (Показать все результаты (>1451) - www.adass.org/ )

• Recognition of Anomalous Events
• Fitting and Modeling in the ASC Data Analysis Environment
• A Computer-Based Technique for Automatic Description and Classification of

As an obligatory preparing for the application to participate in the IAO a short report of National Olympiad of the current year with a set of all problems used on the Olympiad has to be presented by the applicating team. ... The final minutes (protocols written in Latin or Cyrillic in form of tables) of the Olympiad (evaluating of solutions of the students participated in the last stage of the Olympiad) should be included as well. ... Historical data of the National Astronomy Olympiad: . ...

Еще в разделе: (Показать все результаты (>864) - www.issp.ac.ru/ )

• XVI International Astronomy Olympiad, information before Olympiad