Fasti is an innovative design for infrared detector control. ... to use largely accepted standards as boundaries, as a PCI bus, a parallel interface or a serial, and to use few of them . ... The building blocks of Fasti are: . ... the serial bus for controlling housekeeping devices (temperature and pressure sensors or motor controllers) and programming data acquisition . ... Though not so fast, and lacking some forms of data integrity check, this bus is so widely used to be nearly unavoidable. ...

... Science . ... Science Users Information > Observing Facilities > Instrumentation Development > VLT/Instrument Interfaces . ... APEX Visitor Instrument . ... The interfaces between the VLT Unit Telescopes and the scientific instruments to be operated at the VLT Cassegrain, Nasmyth and Coudц© foci are well defined. ... Interface and numerous other relevant information for instrument builders is available in the "Requirements for Scientific Instruments on the VLT Unit Telescopes" , ESO doc. no. ...

... Charge Coupled Devices (CCD) are currently by far the most widely used type of detector in astronomy. ... After a brief introduction to the VLT Control System, the VLT CCD Detectors Control Software is presented. The VLT Control System is a distributed system consisting of a set of UNIX Workstations, dedicated to high level operations, such as coordination of sub-system activities and interface to the users, and VME-based Local Control Units (LCU), dedicated to the control of sub-systems hardware. ...

MRO-ICD-CAM-1100-0108 FTTNAS-FTTA.odt Page 1 of 7 MRO FTT / NAS FLC ICD FTT / NAS Electronics to FTTA Controller ICD MRO-ICD-CAM-1100-0108 The Cambridge FTT Team Rev 1.0 9 May 2013 Cavendish Laboratory JJ Thomson Avenue Cambridge CB3 0HE UK MRO-ICD-CAM-1100-0108 FTTNAS-FTTA.odt Page 2 of 7 ICD Description ... 2.1 Signal definitions.. ... The analogue input interface in the FTT-NAS electronics interface is to accept the full range of output available, specifically: 1. ...

... XmTel is a telescope control interface designed to to communicate with a telescope server, and Elwood Downey's XEphem, through the INDI protocol. It will also operate as a free-standing program for control of telescopes that use the NexStar and LX200 command sets (but see below). ... XmTel is accompanied by routines which support the necessary communication and commands for running Celestron NexStar and Meade Instruments LX200 telescopes. ...

... Created: 23 February 2001 . ... SOFTWARE MAINTENANCE MANUAL . ... 9 January 2001 . ... Note: in the final document, the table of contents will be to third level] . The Software Maintenance Manual describes the procedures for installation and maintenance of the software for the Gemini Near-infrared Integral Field Spectrograph (NIFS). ... Section 19.4.3 of the document “Programmatic Requirements for Gemini Instrumentation Development” states the requirements for the Software Maintenance Manual . ...

This section describes the keywords available for the science instruments planned for installation on HST during Servicing Mission 4: the Cosmic Origins Spectrograph (COS) and the Wide Field Camera 3 (WFC3). ... The COS keywords consist of a list of detectors, apertures, mirrors, gratings, and central wavelengths. FUV spectral simulations are performed by specifying one of the FUV gratings along with a central wavelength. ... The aper keyword is used to perform encircled energy calculations. ...

... Meade Instruments Corporation . ... Autostar Computer Controllers . 497 Autostar . ... One of the most important advances in telescope control in the past 25 years, the Meade #497 Autostar Computer Controller turns the ETX into an automatic celestial object locating system. ... The #497 Autostar Computer Controller plugs into the control panel of ETX-90EC, ETX-105EC, and ETX-125EC telescopes and enables automatic location of more than 30,000 celestial objects. ... about meade | ... Meade 4M | ...

... For the XRBs which are highly variable the concurrent presence of the RXTE/ASM that continuously measures their X-ray spectral states invites a new and innovative program to harness the available information to facilitate detailed studies of individual systems as well as comparative studies between classes of systems. ... This will enable them to quickly decide which data are worth putting in effort to extract and further analyze. ...

TCS is the online Telescope Control System maintained by the Australia Telescope National Facility (ATNF). ... The TCS graphical user interface ( TCS GUI ) written in Glish/Tk running on a unix workstation. A glish client running on the same host as the TCS GUI serving as a communications channel between the TCS GUI and the controller. ... The TCS User Interface manual is available here; . ... More information is available from Mark Calabretta ( mcalabre@atnf.csiro.au ) . ...

. XMM-Newton Science Analysis System . odfbrowser (odfbrowser-1.5) [xmmsas_20080701_1801-8.0.0] . Meta Index / Home Page / Description / Using odfbrowser . The main window shows all exposures of all instruments available in the observation, as denoted by SAS_ODF , together with some general information about the observation: . Subsections . Toolbar . Observation pane . XMM-Newton SOC/SSC -- 2008-07-02

... 1 available ; Nd:YAG based laser transmitter; 24 W average power (100 MW peak power ) at 532 nm; Additional output at 1064 nm fundamental (currently 355 nm is not available ); 6 ns pulse width; 40 Hz operation; 80 cm diameter Cassegrain telescope receiver; Fully pointable (but generally aircraft restricted to within 45 o of zenith; Electronic gated photomultiplier tube detection with low-altitude chopper; Data collection is ... F. Airglow Mirror Systems: . ...

lsst.mirrorCtrl љ 1.0.13 . ... mirrorCtrl: Interface to Galil mirror controllers . ... This package adds the following capabilities to the Galil mirror controllers: Command mirror orientation (piston, tilt and translation) to the extent supported by the actuators. The Galil supports commanding actuator mount, not orientation.) ... The controller has a model of where the actuators, encoders and fixed links are attached to the mirror (at one end) and to the stationary frame (at the other end). ...

Fiber-Optically Interfaced Cameras Princeton Instruments, Inc., offers specialized imaging cameras with fiber optic interfaces. ... Fiber Optic Advantages Fused fiber optics provide very high throughput optical coupling from any flat, light emitting surface to the surface of a CCD array. ... Fiber optic coupling is also not restricted to 1:1 imaging. ... Standard or Intensified Models Available Princeton Instruments offers a wide variety of CCD cameras with fiber optic coupling. ...

... Satellite data ] . SMIS ] . The program controls the data acquisition according to the specified schedule of the sessions. ... The calibration of AVHRR instrument data is performed during acquisition . The program can be started in parallel with the satellite pass visualization, that allows the user to monitor a session and store data only relevant to specific regions in manual selection mode. ... Back to SMIS Home Page . ...

SAI 175 anniversary . ... Moscow University . Search for in SAI Moscow University Search for in Russian astronomical resources . ... SAI Astronomical Databases . ... Browse SAI Software archive(ftp.sai.msu.su) . ASTRONET.RU - Russian Astronomical Network (available in translit also) . ... SAI Supernovae Research Group . ... Department of the Galaxy and Variable Stars (in Russian) . Sternberg Astronomical Institute Seminars . ... All-Russian Astronomical Olympiad (in Russian) . ...

... Iowa Robotic Telescope | ... Talon is based on OCAAS, a software suite developed by software engineer Elwood Downey ( Clear Sky Institute ) for use at the University of Iowa ?s first remote facility (the ATF, or Automated Telescope Facility). ... XObservatory : Telescope Control Interface . ... This program calls upon and coordinates much of the interrelated portions of the Talon architecture, and forms the primary control panel for the telescope, dome, and peripheral systems when used locally. ...

... The general­purpose data reduction package FIGARO is now available to be run from the IRAF CL, and more Starlink applications will follow in due course. ... A system has been developed to enable packages written for the Starlink Software Environment to be run from the IRAF CL so that an IRAF user can mix and match application tasks from the two environments as required to process data, all under the control of the IRAF CL. ... Mixing IRAF and Starlink Applications -- FIGARO under IRAF 179 3. ...

. Pulkovo Observatory of Russian Academy of Sciences is situated . near Saint-Petersburg. It was founded in 1839. 196140, Saint-Petersburg, Pulkovskoye chaussee 65/1 . English version . Russian version . This page has been accessed times since May 1, 1999.

... 4 November 1994 . orbit . ... 0.0128 . ... orbit period . ... satellite mass . 1950 kg . scientific payload mass . 550 kg . ... For more information send a mail to: info@sputnik.infospace.ru . 1997-2002 SMIS IKI RAN and SRC "PLANETA" Moscow, Russia. ...