... For every level we have plotted the dependence between width and Lande factor and obtained the linear regression parameters: the inclination, the zero Lande factor line width and the correlation. ... Fig. 1. presents a model components, the intensity of which decreases (b) line with 10 and increases (c) to the center of spectral line (the field is 12 k6s). ... Our results show strong dependencies of line width on the level of width measurements. ...

We present results of new Monte Carlo calculations made with the DIRTY code of radiative transfer of stellar and scattered radiation for a dusty giant late-type galaxy like the Milky Way, which illustrate the effect of the attenuation of stellar light by internal dust on the integrated photometry of the individual bulge and disk components. ... In addition, we find that the structure of the dusty ISM affects more sensitively the observed magnitudes than the observed colors of both bulge and disk. ...

... The axial support is provided by 78 air pistons. ... The transverse support is provided by 38 air pistons, supported by cantilevers from the mirror cell, that act on the mirror local center of gravity surface. ... The locations where the transverse mirror support forces should be applied to the mirror are listed in Table 1 and illustrated in Figure 1. ... Figure 1: CAD drawing showing the 2.5-m primary mirror and the locations of the transverse support posts (black) and axial pneumatic pistons (blue...

... Can do almost everything that Miriad, AIPS and Difmap can plus more. ... Component Fluxes cont. ... Model fit to VSOP and ground- only VLBI data in Difmap ) Tasks, commands Miriad task Visibility plane model fitting Image plane model fitting Image plane integrated flux Uvfit, uvmodel Difmap command Modelfit AIPS task Uvfit, (slime) Aips ++ function image .fitsky, imagefitter (spatial), image .maxfit, image .fitprofile, imageprofiler image .statistics image .getchunk, ...

... The HST uses an onboard model of its orbit to perform in real-time various control functions relating to spacecraft operations and observation support. ... New coefficients for the ephemeris are updated every other day, and are archived as FITS keywords for each HST observation data set. Using these coefficients,an observer can perform a variety of calibration and characterization calculations relating to the orbital position and velocity of the telescope. ...

... Laboratory for Spectroscopy of Molecular Structures . ... Optics and spectroscopy of molecular and liquid crystals, fullerenes, superthin molecular films. Optical studies of structure, phase transitions, pretransitional phenomena, structural modifications in external field and under high pressure. ... Methods developed in the laboratory enable to determine in free standing films of different types liquid crystals values of polarization, two-dimensional constants of orientational elasticity. ...

Next: General CCF Components Up: Calibration Access and Data Previous: List of CAL Routines Contents . This section contains descriptions of the structure of CCF constituents. ... The calibration team of the SOC is also providing additional CCF components where required in conjunction with data that were generated with SciSim. ... These CCF components are generated on a need basis and are identical in structure to the real life components. ... Generation from Ground Calibration Data . ...

Next: Star Formation Rate and Up: No Title Previous: Calculation of Evolutionary Tracks . To start calculations, we choose the distributions of the initial binary parameters: the mass of the primary ZAMS component, , binary mass ratio, , orbital separation a . ... whereas the mass ratio distribution is not. ... The zero assumption often made is that the mass ratio distribution has a flat shape, that is binaries with a high mass ratio occur as frequently as those with equal masses. ...