Документ взят из кэша поисковой машины. Адрес
оригинального документа
: http://zebu.uoregon.edu/1995/ph161/l3.html
Дата изменения: Fri Oct 3 22:33:52 1997 Дата индексирования: Tue Oct 2 00:08:59 2012 Кодировка: Поисковые слова: south pole |
Remember Ohms law from last time. Here are two circuits below. If you know Ohms law you should be able to make the light come on in one only one try as the amperage, I, is now specified.
In the early 19th century the following similarity between two charged particles and two magnets was observed:
In 1820 Oersted did this experiment:
and discovered that an electric current creates a magnetic field
Similarly, a coil of wire with a current passing through it generates a magnetic field. This is known as an electromagnet or solenoid .
So now we know that a current can create a magnetic field. If a magnetic field can create a current then we have a means of generating electricity. Experiments showed that a magnetic just sitting next to a wire produced no current flow through that wire. However, if the magnet is moving a current is induced in the wire. The faster the magnet moves, the greater the induced current.
This is the principal behind simple electric generators in which a wire loop is rotated between to stationary magnetics. This produces a continuously varying voltage which in turn produces an alternating current .
Diagram of a simple electric generator:
![]() |
In this position there is no current flow but their is a large potential difference (a large voltage) |
---|---|
|
In this position the Voltage is now zero and the current flow is at a maximum |
Popular Methods of Turning the Crank:
Why do transmission lines carry such high voltages?
Consider the following:
Current = Power/Voltage; If we increase V by a factor of 10, then I lowers by a factor of 10 (at constant power) and the power dissipated as heat lowers by a factor of 102.
Hence at 1200 Volts we have only 69.4 watts of energy loss and a 99% enery efficient delivery system.
How to change the voltage: --> Use a Transformer
![]() |
A transformer uses alternating current in one coil to induce alternating current in another. The induced voltage is given by: Vout = Vin x N2/N1 where N1 = Number of coils in the Primary and N2= Number of coils in the secondary. When N2 is less than N1, we reduce Vout. This is why there are transformers on power lines to step the voltage down to 120 Volts by the time it reaches your house. |
---|
Energy conservation tells us that Power In = Power Out
so
And that's the way the world works.
Internet Resource Alert