Документ взят из кэша поисковой машины. Адрес
оригинального документа
: http://www.stsci.edu/stsci/meetings/irw/proceedings/ching.dir/section3_2.html
Дата изменения: Mon Apr 18 20:28:07 1994 Дата индексирования: Sun Dec 23 19:16:56 2007 Кодировка: Поисковые слова: п п р р р р р р р р р р р р р р |
The procedure used to recover both spectra and images or, alternatively, to map from one type of PSF to another, is the same and is outlined below:
We first made preliminary studies investigating recovery of images that have been broadened by the HST's mirror by modeling its PSF as shown in Fig. 1. At left is a simple PSF based on a superposition of two Gaussians, and at right is a typical Tiny TIM PSF for HST's Wide Field/Planetary Camera.
The results of applying our procedure outlined above are given in Fig. 2. At left is the original ground-based image of M82. The middle image shows the M82 data degraded by our model PSF. At right is the recovered estimate of the image using the procedures outlined above. Note that the estimated image does not use any knowledge of the original image. Fig. 3 shows how well the recovery process works in the presence of artificially added noise.
We have also applied our recovery procedure to HST images accessible from the ST ScI image restoration test data sets. Our results for HST images are shown in the following figures. Fig. 4 is an HST image of Jupiter, our enhancement, and a comparison with a Richardson-Lucy enhancement (provided by Bob Hanisch). The PSF used is a Tiny Tim model PSF. Fig. 5 shows our recovery of an HST image of Saturn using an observed 53x53 point HST PSF. Fig. 6 is based on an IRAF M51 image from the ST ScI test data set. The Tiny Tim-PSF processed image used as a starting point in our processing is also from the image restoration test data set. Our recoveries from test images with and without noise are shown with a Richardson-Lucy recovery with noise (also from the ST ScI test data set). We believe that our method compares well with the Richardson-Lucy method, but have not made any quantitative comparisons.
Our recovery procedure was applied also to spectral data, in this case to a
tunable diode laser (TDL) spectrum. The TDL observation of 13 m propane
is shown in Fig. 7. The second row shows an example of a
constrained signal
space deconvolution of this spectrum, using a nonlinear method (after
Blass and Halsey 1981 and
Jansson 1984). The other plots are examples of resolution enhancement
using the our procedure with the target function being Gaussians having a full
width at half maximum (FWHM) of 2 data points, 3 data points, and a unit
impulse function, respectively. The TDL PSF is modeled with a Gaussian having
a FWHM of 6 data points. The use of targeted PSFs is discussed in more
detail below.
Fig. 8 shows that it is practical to map a spectrum from a
sinc apodization to a positive semi-definite distribution using our numerical
procedure. A sinc point spread function (top, Fig. 8) is
mapped to a sinc function (middle, Fig. 8), and to a
Gaussian function (bottom, Fig. 8) using the linear filters
derived from our procedure.
One benefit of applying our extended instrument model is the ability to cascade
a series of filter functions to achieve a desired end result. For example, we
can model the response of a Fourier Transform Spectrometer (FTS) spectrum whose
PSF is a sinc function and to map its response to a sinc apodized spectrum
using our procedure. The numerically apodized spectrum was then deconvolved
(restored) using a nonlinear constrained signal space deconvolution algorithm.
The ``true'' spectrum (before observation) is shown at the top of Fig.
9. The second row of Fig. 9 shows an observation from a
simulated FTS spectrometer. The third row shows the sinc
apodized
spectrum. An estimate of the true spectrum derived from the apodized spectrum
is shown in the bottom row by applying a further inverse filter.
The instrumental convolution is characterized by
Eq. 1, a Fredholm
integral equation of the first kind. In principle, one can analytically solve
for by using Fourier transform theory. The instrument model equation is
and its Fourier Transform then is
.
Rearranging and using the inverse Fourier Transform, one recovers an
estimate of
This direct inversion has serious problems:
is not well behaved, in particular
it amplifies noise. The convolution network searches for an approximate
that minimizes an error function,
, where
is the
target function. The convolution network is derived from the
error-backpropagation neural network model with a slightly more complex, yet
more natural connection scheme for imaging systems. Many deconvolution
algorithms use a correction term, e, of the form:
The convolution network involves a correction that has the form:
where is the point spread function and
is the desired
result of the mapping (i.e., for a sinc
function mapped to a
sinc
function,
is the sinc
function,
is a sinc
function, and
is the function that minimizes
).
After determining
, the application of the convolution network is
computationally inexpensive since it involves only a convolution. It is
feasible to build an instrument that can be tailored for real-time data
enhancement/processing via several filter functions,
, as shown in Fig.
6.