Документ взят из кэша поисковой машины. Адрес
оригинального документа
: http://www.stsci.edu/hst/acs/hst/wfc3/documents/handbooks/currentIHB/c07_ir03.html
Дата изменения: Unknown Дата индексирования: Tue Apr 12 10:37:30 2016 Кодировка: Поисковые слова: п п р с с р р п п п п п п п |
WFC3 Instrument Handbook for Cycle 24 |
help@stsci.edu |
In the HST proposal system, the parameters for an IR observation available to General Observers are:
1. Configuration: always WFC3/IR.
2. Mode: always MULTIACCUM.
3.
4. Spectral Element: must be specified for each exposure; see Section 7.5.
5. Optional Parameters: in the IR channel SAMPSEQ specifies a predefined sequence of times at which the detector is read out, and NSAMP specifies the total number of readouts (and thus the total exposure time); see Section 7.7. SAMPSEQ and NSAMP are required for IR observations.
6. Special Requirements: see the Phase II Proposal Instructions for details of Special Requirements related to the timing of visits and for dithering and mosaicking. Also available is the exposure-level Special Requirement POS TARG for offsetting the target from the default reference point of the aperture (see Section 7.4.3 for a discussion of the IR channel coordinate system).
7. Number of Iterations and Time per Exposure: in cases where two or more identical exposures are desired, the Number of Iterations may be set to 2 or more. In the IR channel, the Time per Exposure is fixed by the combination of SAMPSEQ and NSAMP (see item 5 above) and thus is not specified separately. Through various combinations it is possible to select times per exposure ranging from 2.93 to 2756 s (for readouts of the full detector array; considerably shorter exposures are possible using subarrays).