|
Документ взят из кэша поисковой машины. Адрес
оригинального документа
: http://www.stsci.edu/ftp/documents/system-docs/vms-guide/html/VUG_13.html
Дата изменения: Wed Nov 1 17:38:22 1995 Дата индексирования: Sun Dec 23 18:29:50 2007 Кодировка: |
Generated with CERN WebMaker
Login Problems
Nothing shows up on the terminal screen
? (Some terminals may have a screen saver program enabled). The terminal is on, but you can't type anything
-
and try again. 
key (
on some terminals) and look for a switch called "LINE/LOCAL." Make sure it is set to "LINE." The terminal responds with garbage
If you get upside down question marks or other garbage, then check the line speed of the terminal. It should be set to either 9600 or 19200 baud. Terminal speed can be checked by pressing 
, then moving to the selection marked "Comm," and looking for the fields marked "Transmit=" and "Receive=". These fields should be set to 9600 or 19200. Reset the terminal. This is done by pressing 
and then moving the cursor to the selection marked "Reset," then press 
. The terminal works, but you can't get into the system
after both your username and password? Xyplex Problems
The following are some messages that you may see, and suggestions for what you can do to alleviate possible problems. "Service ... not known"
"Trying to connect to..."
"Session used" or "Cannot exceed session limit"
who or show session). Select an available session. "Insufficient resources at remote node"
"Maximum number of users exceeded" or "No response within timeout period"