Документ взят из кэша поисковой машины. Адрес
оригинального документа
: http://www.stsci.edu/documents/dhb/web/c29_wfpc2data.fm3.html
Дата изменения: Tue Nov 18 00:20:31 1997 Дата индексирования: Sat Dec 22 15:38:30 2007 Кодировка: Поисковые слова: earth's atmosphere |
http://presto.stsci.edu/public/propinfo.htmlThe first step is often identifying to which program a data file belongs, which can be accomplished via the header keyword PROPOSID. Data files can then be associated with the corresponding exposure line in the Phase II proposal by comparing exposure information in the Phase II proposal with data file header keywords. For WFPC2 data, the most useful comparisons are shown in the table below.
Phase II |
Data Header |
---|---|
Target_Name
|
TARGNAME
|
Position
|
RA_TARG, DEC_TARG
|
Spectral Element
|
FILTNAM1
|
Time_Per_Exposure
|
EXPTIME
|
A convenient tool for viewing some of the most important data header keywords in an easy-to-read formatted output is the STSDAS task iminfo. An example of the output of this task in shown in Figure 25.1. Note that the data header keywords are expanded to standard English words in this output. The header file (.c0h extension) can also be examined with IRAF tools hedit or imheader, with any standard text editor, or simply by listing the contents of the file. Again, please note that a standard text editor will not display the group keywords, which are stored in the image file.
In the specific example shown in Figure 25.1 we see that the Proposal ID is given as 05837. Entering the proposal ID into the space provided on the Web page listed above (without the leading 0) and clicking on [Get Program Information]. brings up the Program Information page for that proposal. Under Program Contents on that page you can choose either the file typed in during Phase II or a formatted output. The latter may be easier to read; we reproduce a portion of that file in Figure 25.2.
The Exposure ID listed by iminfo is 02-023. This corresponds to visit 02, exposure 23. A different format was used in Cycles 0 through 4; exposures in these proposals have a single, unique numeric identifier. To reach this exposure line, page down through the proposal until visit 02 is reached. Now search for exposure 23 in visit 02. As shown in Figure 25.2, this exposure requested a single 5 second exposure of target CAL-GANY-W through filter F410M. A quick comparison with the keywords listed by iminfo shows that, indeed, this data file contains the observation specified in this exposure line.
Figure 25.2: Exposure Log Sheet for WFPC2
A comparison of these keywords should quickly reveal the data file corresponding to a given exposure line. There are, however, two cases in which such a comparison is somewhat more complicated.
cl> hselect u2p60204t.c0h FGSLOCK yesThe FGSLOCK keyword can have the values FINE, COARSE, GYROS, or UNKNOWN. Coarse tracking is no longer allowed, so this keyword in recent data will most likely read either FINE or GYROS. Gyro tracking allows a drift rate of approximately 1 mas/sec. It would only be used if requested by the proposer. FINE tracking typically holds pointing with an rms error of less than 7 mas. Typically two guide stars are used in HST observations, but on occasion only one appropriate guide star can be found. Such observations will suffer from small drift rates (a few mas in a 1000 second exposure). If you suspect the quality of tracking obtained during your observations, please review Appendix C which describes how to determine the number and quality of guide stars actually used as well as how to use the OMS jitter files.
FINE