Документ взят из кэша поисковой машины. Адрес
оригинального документа
: http://www.sao.ru/precise/Midas_doc/doc/95NOV/vol2/node171.html
Дата изменения: Fri Feb 23 12:57:29 1996 Дата индексирования: Tue Oct 2 17:51:31 2012 Кодировка: Поисковые слова: п п п п п п п п п п п р п р п р п р п р п р п р п р п р п р п р п р п р п р п р п р п р п р п р п р п р п р п р п р п р р п п р п п р п |
Input data observed with the same configuration of the instrument and the parameters needed for the reduction define a session. Session parameters are listed by the command SHOW/ECHELLE. It is recommended to use this command to control the actual status before executing any further reduction step. Current parameters are saved with the command SAVE/ECHELLE name, where name is the session name. This command will be used whenever you want to interrupt a session which then can be restarted at any other time. Current parameter values are set to the default value with the command INIT/ECHELLE, or set to the values of a previously saved session with INIT/ECHELLE name.
Relevant session parameters can be defined for each command in the usual way:
command/qualifier parameters
or can be defined in explicit form as
SET/ECHELLE param=value [param=value ...]
where param is the parameter name and value is the assigned value. The assigned values will be maintained until you save them for later reference. Current parameter values are re--assigned either by INIT/ECHELLE or by another SET/ECHELLE command.
Please note that the session concept is part of the high level command structure (level 1 and above). If level 0 commands are used one has to specify explicitely ALL the parameters required by the level 0 commands, despite the fact that some of them may already have been set via SET/ECHELLE.