The Session Manager

Input data observed with the same configuration of the instrument and the parameters needed for the reduction define a session. Session parameters are listed by the command SHOW/ECHELLE. It is recommended to use this command to control the actual status before executing any further reduction step. Current parameters are saved with the command SAVE/ECHELLE name, where name is the session name. This command will be used whenever you want to interrupt a session which then can be restarted at any other time. Current parameter values are set to the default value with the command INIT/ECHELLE, or set to the values of a previously saved session with INIT/ECHELLE name.

Relevant session parameters can be defined for each command in the usual way:

command/qualifier parameters

or can be defined in explicit form as

SET/ECHELLE param=value [param=value ...]

where param is the parameter name and value is the assigned value. The assigned values will be maintained until you save them for later reference. Current parameter values are re--assigned either by INIT/ECHELLE or by another SET/ECHELLE command.

Please note that the session concept is part of the high level command structure (level 1 and above). If level 0 commands are used one has to specify explicitely ALL the parameters required by the level 0 commands, despite the fact that some of them may already have been set via SET/ECHELLE.