Документ взят из кэша поисковой машины. Адрес
оригинального документа
: http://www.sao.ru/hq/lrk/gifs/mars2en.html
Дата изменения: Unknown Дата индексирования: Sun Apr 10 05:46:17 2016 Кодировка: Поисковые слова: п п п п п п п п п |
Three-module experimental radiometric matrix was designed and put
in operation successfully. Flowchart of the one channel is shown
in Figure 1. The receiver module is about the same, as for
Figure 1. MARS-2. Flowchart of the single channel.
The input switch is a latching WR-28 waveguide circulator,
driven by alternate polarity current pulse sequence ( I = 8 - 10 A;
t = 2 - 3 s; T = 5 - 10 ms ).
Typical values for the switch are loss not more than 0.3 dB and
isolation not less than 20 dB for frequency band 28 - 32 GHz.
In figure 2 the receiver module and switch assembly is shown.
Figure 2. The receiver module and switch assembly. The elementary radiometers are combined ( figure 3 ) into the microwave unit ( one pair of horns shown is out of use ), where they integrated to use unified systems for calibration, power supply and temperature control. Figure 3. HF part of the MARS-2 radiometric system.
The MARS-2 system was installed at the feed cabin No.1 of the
RATAN-600 radio telescope Figure 4. The focal line of the RATAN-600 radio telescope ( feed cabin No.1 ).
To illustrate the results, two beam-switching recordings of
the radio source are shown in Figure 5. Sensitivity comparison of the MARS-2 uncooled elementary radiometer and of the cryoradiometer at nearest wavelength 1.38 cm. The results of the MARS-2 investigation are used now as a basis for development of the next phase of the Project - 16 module matrix MARS-3 [2].
|