Документ взят из кэша поисковой машины. Адрес
оригинального документа
: http://www.naic.edu/~phil/hardware/nvidia/doc/driverInstall/chapter-06-section-02.html
Дата изменения: Fri Oct 30 20:31:11 2009 Дата индексирования: Tue Nov 24 16:35:52 2009 Кодировка: Поисковые слова: m 63 |
In April 2004 the X.Org Foundation released an X server based on the XFree86 server. While your release may use the X.Org X server, rather than XFree86, the differences between the two should have no impact on NVIDIA Linux users with two exceptions:
The X.Org configuration file is /etc/X11/xorg.conf
while the XFree86
configuration file is /etc/X11/XF86Config
. The files use the same
syntax. This document refers to both files as “the X config file”.
The X.Org log file is /var/log/Xorg.#.log
while the XFree86 log file is
/var/log/XFree86.#.log
(where
#
is the server number -- usually 0).
The format of the log files is nearly identical. This document
refers to both files as “the X log
file”.
In order for any changes to be read into the X server, you must edit the file used by the server. While it is not unreasonable to simply edit both files, it is easy to determine the correct file by searching for the line
(==) Using config file:
in the X log file. This line indicates the name of the X config file in use.
If you do not have a working X config file, there are a few
different ways to obtain one. A sample config file is included both
with the XFree86 distribution and with the NVIDIA driver package
(at /usr/share/doc/NVIDIA_GLX-1.0/
).
The nvidia-xconfig
utility, provided with the NVIDIA driver package, can generate a
new X configuration file. Additional information on the X config
syntax can be found in the XF86Config manual page (man XF86Config
or man xorg.conf
).
If you have a working X config file for a different driver (such as the “nv” or “vesa” driver), then simply edit the file as follows.
Remove the line:
Driver "nv" (or Driver "vesa") (or Driver "fbdev")
and replace it with the line:
Driver "nvidia"
Remove the following lines:
Load "dri" Load "GLCore"
In the Module
section of the
file, add the line (if it does not already exist):
Load "glx"
If the X config file does not have a Module
section, you can safely skip the
last step if the X server installed on your system is an X.Org X
server or an XFree86 X release version 4.4.0 or greater. If you are
using an older XFree86 X server, add the following to your X config
file:
Section "Module" Load "extmod" Load "dbe" Load "type1" Load "freetype" Load "glx" EndSection
There are numerous options that may be added to the X config file to tune the NVIDIA X driver. See Appendix B, X Config Options for a complete list of these options.
Once you have completed these edits to the X config file, you may restart X and begin using the accelerated OpenGL libraries. After restarting X, any OpenGL application should automatically use the new NVIDIA libraries. (NOTE: If you encounter any problems, see Chapter 8, Common Problems for common problem diagnoses.)