Äîêóìåíò âçÿò èç êýøà ïîèñêîâîé ìàøèíû. Àäðåñ îðèãèíàëüíîãî äîêóìåíòà : http://www.naic.edu/~pfreire/orbits/
Äàòà èçìåíåíèÿ: Sat Dec 20 23:36:29 2008
Äàòà èíäåêñèðîâàíèÿ: Tue Oct 2 00:07:55 2012
Êîäèðîâêà:
Ïîèñêîâûå ñëîâà: 47 ï ï ï ï ï ï

Orbits in the period / acceleration plane

Pulsar orbits the period-acceleration plane

Paulo C. Freire, M. Kramer and A. G. Lyne

Introduction

Binary orbits in the acceleration/period plane

Circular Orbits

Summary

Introduction

The discovery of a pulsar whose period changes significantly during the observation usually indicates that it is a member of a binary system. It is then important to determine the Keplerian orbital parameters of the system in order to investigate the astrophysics of the two stars and to obtain a coherent timing solution for the rotation of the pulsar.

The usual procedure for obtaining orbital parameters involves fitting a Keplerian model to a series of period measurements specified in time. Such a procedure works well, provided that it is possible to determine the rotational period on several occasions during a single orbit. However, there are often circumstances where this is not the case, such as where interstellar scintillation permits only sparse positive detections of a pulsar. This is the case of most of the millisecond pulsars in 47 Tucanae.

In what follows, we present a simple procedure for estimating the Keplerian orbital parameters of a binary that is completely independent of the distribution of the epochs of the individual observations. The only thing that is required is that the period derivatives (or accelerations) are known in each observation. Estimates of accelerations or period derivatives are normally provided by acceleration surveys, and can be easily refined using the technique of pulsar timing

We first present the equations for the period and acceleration of a pulsar in an eccentric binary system as a function of its position in the orbit. We then provide an analysis of the circular case. In Freire, Kramer & Lyne (2001) (from where most of this text and following equations are taken), we describe in more detail how circular binary orbits can be determined from the observed periods and accelerations of the pulsar.

Binary orbits in the acceleration/period plane

Figure 1 represents the orbit of a binary pulsar (point P) around the centre of mass of the system (O) projected onto a plane that contains the direction towards the Earth (i.e., perpendicular to the plane of the sky, $\Pi$ ), and the line of nodes where the orbital plane intersects $\Pi$ . IN THIS PLANE, the orbit is an ellipse of eccentricity and projected semi-major axis $a = a' \sin i$ ( is the unknown inclination of the orbit relative to the plane of the sky). Still in the same projected plane, r is the vector connecting O to the pulsar's projected position, P, and $r\, = \, \vert {\bf r} \vert$ is the distance of the pulsar to O, $r_{l}\, = \, \vert {\bf r_l} \vert$ is the projection of this to the line-of-sight. $\omega$ is the longitude of periastron and is the angle of the pulsar to the periastron measured at O, also called "true anomaly". According to Roy (1988), the equation for $r_{l}$ as a function of is given by

$\begin{displaymath} r_{l}(f) = r \sin ( \omega + f) = a (1 - e^2) \frac{ \sin ( \omega + f )}{1 + e \cos f} \end{displaymath}$

(1)

ERRATUM: Note that the last term in this equation includes a

term that was mistakenly missed in equation 1 in Freire, Kramer & Lyne (2001). This does not affect equation 2 of that paper, which was correctly derived from the first equality in equation 1, but it affects equation 4 of that paper, which is missing a

term in the denominator. A corrected version of the latter equation is presented below as equation 8.

The time derivative of $r_{l}$ is the line-of-sight (or radial) velocity, $v_{l}$ . Using the results in Roy (1988):

$\displaystyle \dot{r}$	$\textstyle =$	$\displaystyle h' e \sin f,$	(2)
$\displaystyle r \dot{f}$	$\textstyle =$	$\displaystyle h' (1 + e \cos f),$	(3)
$\displaystyle h'$	$\textstyle =$	$\displaystyle \frac{2 \pi}{P_B} a \sqrt{1 - e^2},$	(4)

we obtain:

$\begin{displaymath} v_{l}(f) = \frac{2 \pi}{P_{B}} a \sqrt {1 - e^2} \left\{ \cos (\omega + f) + e \cos \omega \right\}, \end{displaymath}$

(5)

where is the orbital period of the binary. The apparent rotational period of the pulsar as a function of and the intrinsic rotational period is given by

$\begin{displaymath} P(f) = P_{0} \left( 1 + \frac{v_l(f)}{c} \right) \left( 1 - ... ...t)^{-1/2} \simeq P_{0} \left( 1 + \frac {v_ {l}(f)}{c} \right) \end{displaymath}$

(6)

if the total velocity of the pulsar, is small compared to .

Differentiating equation 6, we obtain the acceleration of the pulsar along the line of sight:

$\begin{displaymath} A_{l}(f) \equiv \dot{v_l}(f) = c \frac{\dot{P(f)}}{P(0)}, \end{displaymath}$

(7)

This is how we convert the period derivatives to accelerations.

Differentiating equation 5 in time, we obtain $A_{l}$ as a function of

$\begin{displaymath} A_{l}(f) = -\left( \frac{2 \pi}{P_{B}} \right)^2 \frac{a}{1 - e^2} (1 + e \cos f)^2 \sin(\omega + f). \end{displaymath}$

(8)

Plotting $A_{l}(f)$ as a function of , we obtain a parametric curve that does not depend on time, and therefore does not require the solution of Kepler's equation. This curve is illustrated in Figure 2 for a binary pulsar of spin period 10 ms and orbital parameters = 0.9, $\omega = 140 ^ \circ$ , $P_{B}$ = 1 day and $x\, \equiv\, a_P/c = a_{P}'\, \sin i / c = 5.263157895 s$ (this figure, taken from Freire, Kramer & Lyne (2001), under-estimates the accelerations by the term that was missed in eq. 4 of that paper).

Circular Orbits

The vast majority of Galactic binaries containing "true" millisecond pulsars, i.e., those with periods below 20 ms, have rather circular orbits (see, e.g., the ATNF Pulsar Catalog). For these, we can set $e = \omega$ = 0 in the equations above, so that equations 6 and 8 reduce to

$\begin{displaymath} P(f) = P_{0} + P_{0} x \frac{2 \pi} {P_{B}} \cos f \equiv P_{0} + P_{1} \cos f \end{displaymath}$

(10)

and

$\begin{displaymath} A(f) = - \frac {4 \pi^2}{P_{B}^2} x c \sin f \equiv -A_{1} \sin f. \end{displaymath}$

(11)

The track followed by such pulsars in the period/acceleration space is thus an ellipse centred on the point ( $P_ {0}$ , 0) and having as horizontal and vertical semi-axes the values $P_{1}$ and $A_{1}$ respectively, with the pulsar moving in a clockwise direction.

47 Tuc W

47 Tuc S

47 Tuc T

Inf Figure 3, we can see that these equations describe perfectly the observed periods and accelerations of two pulsars with hitherto unknown orbits (47 Tuc T and 47 Tuc S), and of a previous pulsars with a known orbit (47 Tuc W). The method used to determine the best ellipse fit is described in the Appendix of Freire, Kramer & Lyne (2001). Once this fit is done we can easily recover the two relevant orbital parameters in a circular orbit from the best ellipse's $P_ {0}$ , $P_{1}$ and $A_{1}$ :

$\begin{displaymath} P_B = \frac {P_1}{P_0} \frac {2 \pi c}{A_1}, \end{displaymath}$

(12)

$\begin{displaymath} x = \left( \frac{P_1}{P_0} \right)^2 \frac {c}{A_1}. \end{displaymath}$

(13)

Using these newly determined orbital parameters, we can calculate the angular orbital phase for each th data point, i.e. for each pair of acceleration and period measured (, ):

$\begin{displaymath} \phi_k = \arctan \left( - \frac {A_k}{A_1} \frac{P_1}{P_k - P_0} \right) \end{displaymath}$

(14)

Since the time of each observation is also known, we can determine the time of the nearest ascending node, or simply $T_{\rm asc, k}$ for each observation:

$\begin{displaymath} T_{\rm asc, k} = T_k - \frac{\phi_k}{2 \pi} P_B \end{displaymath}$

(15)

We can use these values to achieve the correct orbit count between any two observations. One metod of doing this is descibed in Freire, Kramer & Lyne (2001), another more intuitive method is described in Chapter 4 of my Ph.D. Thesis (.ps.gz,.pdf.gz).

Summary

The equations above describe only the mathematical principles of orbit determination from observed barycentric periods and accelerations. For practical algorithms that solve the circular case, please refer to Freire, Kramer & Lyne (2001), particularly to its Appendix.

Using these methods, we can find the orbital parameters of any binary pulsar, no matter how badly under-sampled, as long as the accelerations are measurable. But this method is useful in a more general situation. It can provide a scientifically sound starting point in a "Time-Period" fit, even when the orbit is reasonably well sampled. Until now, this starting solution always involved some degree of guessing.