Документ взят из кэша поисковой машины. Адрес
оригинального документа
: http://www.naic.edu/~astro/spectral_line/handbook_old/node10.html
Дата изменения: Thu May 31 22:50:55 2001
Дата индексирования: Sat Dec 22 22:15:33 2007
Кодировка:
Поисковые слова: virgocluster
This is the optimum mapping routine (in terms of giving the flattest baselines)
for the Arecibo/Gregorian system.
The intent of the routine is for the user to map an area slightly
larger than the area in which he/she is interested. Baseline
subtraction then occurs via fitting a baseline between the opposite ends of each scan
(Figure 1).
Figure 1: Example showing 'typical' mapping techniques for baseline removal.
A number of decisions have to be made when running this routine:
Number of Strips:
This is the total number of strips to be covered for the map. The map size (in declination),
is then (Number of strips - 1) X (Dec step) + (Beam size).
If you wish to do a complete map, you must have
(Number of strips) = 2 X INT[(Dec Offset)/(Dec Step)+0.5] +1
Time per strip:
This is the length of ``drift time" for each strip, and it sets the map size
in the RA direction. For computing this time, just note that the sky
will drift by at 15 arcseconds/sidereal seconds.
There are 1.0027379 sidereal seconds per solar second.
Each strip ill be centered such that its center will be the RA given by
your source list, while the center of the central strip will be centered
on your listed Declination.
RA Offset time:
This procedure differentiates between solar and sidereal seconds.
The integration times of the correlator, and drift times for the
strip are measured in solar (or UTC) seconds. The 1-second ticks
from our atomic clock drives this. Setting this option
to ``solar" will give a slightly funny RA offset, but the
routine will do a better job than the ``sidreal'' settgin aligning the map relative to the
correlator integrations (as long as driftTime is divisible by corRecSecs).
Note that the zenith angle position of the telescope for each strip is set
by the starting RA ([object RA] + [RA Offset]/2) and the current LST.
Dec Offset:
This is the starting offset from the map center for the declination strips, in arcminutes.
A complete map is then 2 X (Dec offset) wide.
If you wish to do a complete map, you must have (Number of strips) =
2 X INT[(Dec Offset)/(Dec Step)+0.5] +1
Dec Step:
This is the amount by which the declination is stepped at the end of a
strip in arcmin (or series of strips, if the number of strips per step is larger than one).
If you wish to do a complete map, you must have (Number of strips) =
2 X INT[(Dec Offset)/(Dec Step)+0.5] +1
Strips per Step:
This setting allows you to integrate multiple strips before stepping in declination.
Doppler Update;
This setting allows you to update the Doppler parameters either once at
the beginning of your map or at the beginning of each strip.
Cal & Cal Time:
These are simply the noise diode options described in Section 1.6,
with the additional option of setting the integration time for the calibration scan.
The noise diodes are fired at the end of each strip.
Settle time:
This setting tells the routine to delay for an extra x seconds at the start of each
strip before taking data. This gives any oscillations in the
azimuth arm extra time to settle down.
Doppler Correction:
This is described in Section 1.7.