Документ взят из кэша поисковой машины. Адрес
оригинального документа
: http://www.mrao.cam.ac.uk/yerac/osullivan/osullivan.html
Дата изменения: Mon Dec 8 18:16:50 2003 Дата индексирования: Tue Oct 2 04:51:39 2012 Кодировка: Поисковые слова: п п п п п п п п п п п п п |
Please Note: the e-mail address(es) and any external links in this paper were correct when it was written in 1995, but may no longer be valid.
Créidhe
O'Sullivan
e-mail:
creidhe@mrao.cam.ac.uk
Mullard Radio Astronomy Observatory, Cavendish Laboratory, Madingley Road, Cambridge CB3 0HE, UNITED KINGDOM
Temperature anisotropies in the CMBR are expected to result from
inhomogeneities in the distribution of matter at the surface of last
scattering. Measurements of these primordial anisotropies provide powerful
constraints on theories of structure formation in the early Universe.
Observations on different angular scales probe the amplitude of structures on
different mass scales. On angular scales greater than , the
Sachs-Wolfe effect (resulting in a scale-invariant spectrum) is expected to be
the principal cause of anisotropy Sachs & Wolfe (1967). The COBE satellite has
already detected anisotropies at a level of
on an angular scale of about
Smoot et al. (1992). Many
current experiments are sensitive to degree scales, with both detections and
upper limits similar to that of COBE (see
Schuster et al. (1993),Gundersen et al. (1993),Cheng et al. (1994),Ganga et al. (1993)). There have also been attempts to detect
anisotropies on arcminute scales (e.g. Subrahmanyan et al. (1993),Fomalont et al. (1993),Myers et al. (1993)). On angular
scales in the range
Doppler effects at the surface of last scattering
are expected to result in large peaks in the amplitude of the fluctuation
spectrum. The Cosmic Anisotropy Telescope (CAT) has been designed to detect
primordial anisotropies in this angular-scale range.
The CAT Robson et al. (1993) is a three-element interferometer which can operate at any
frequency between 13 and 17 GHz with a bandwidth of 500 MHz. This frequency
range was chosen as a compromise between the effects of atmospheric emission,
which increase with frequency, and Galactic synchrotron and bremsstrahlung
emission, which decrease with frequency. The CAT has a system temperature of
approximately 50 K. Variations in the system temperature are continuously
measured using a modulated 1-K noise signal injected into each antenna. The
baselines can be varied from 1 to 5 m, and are scaled to give the same
synthesised beam at different frequencies. The antennas have a primary beam
FWHM of at 15 GHz. The CAT simultaneously records data from
orthogonal linear polarizations. Its alt-az mount causes the plane of
polarization to rotate on the sky as the telescope tracks a given field.
The CAT is situated within a 5-m high earth bank which is lined with aluminium.
This shielding reduces the effect of spillover and terrestrial radio
interference, but limits observations to elevations above . The
control hut is located about 100 m away. Each element of the telescope is a
corrugated conical horn with a parabolic reflector. The horns are mounted on a
single turntable which can track in azimuth. Each antenna has an individual
elevation drive. Preliminary test have shown that crosstalk, correlator
offsets, and antenna shadowing - particular problems associated with
interferometers - do not affect the performance of the CAT at elevations
greater than
(Robson (1994),O'Sullivan et al. (1995)).
There are several factors to be considered when choosing a field for deep CMBR
observations. Most importantly it must lie away from regions of bright radio
emission such as the Galactic plane and bright discrete radio sources. The
408-MHz all-sky radio survey of Haslam et al. (1982) was convolved with a
beam and used to locate suitable low brightness regions of the sky. Fields at
high declinations were most suitable for CAT observations as they were above
the screen for longer periods. Fields were discarded near to the north
celestial pole, where the natural fringe frequency of the sky was too low to
provide useful distinction between wanted and unwanted signals. The Green Bank
4.85-GHz sky maps Condon et al. (1989) were used to locate regions of the sky
relatively free from bright discrete radio sources, difficult for such a large
field of view as that of the CAT. One field (referred to as CAT1) at RA
, DEC
(B1950) contained few sources brighter than
5 mJy (at 4.85 GHz) within the half-power points of the primary beam, and
observations were carried out here over an extended period.
The CAT1 field was observed for six weeks from 1993 December to 1994 February.
During this period the field was above the screen for about 16 hours each
night. No observations were made below an elevation of . The
observations were made at night to avoid solar interference. Cas A was observed
for 1 hour at the beginning and end of each night's run for calibration
purposes.
The measured visibility amplitudes were adjusted to take account of the
variations in gain as a result of system temperature fluctuations. Flux density
and phase calibrations were then carried out using the observations of Cas A.
The phases of the recorded signals were reduced in software to a common
reference at the pointing centre. Calibrated data were averaged over 100 s
before being converted to FITS format and passed to the NRAO AIPS
package for further processing. Each night's data was scanned by eye and all
sections obviously affected by interference or atmospheric emission were
discarded. Even if the interference was only evident on the shorter spacings,
data taken during the relevant time period were discarded from all baselines.
The bad points were easy to detect (Robson et al. (1994)) and more than 60 per
cent of the data were used in making the final map. A 3-
clip was
also applied to minimize the effect on the final map of single-point
excursions. The rms noise level of the remaining data showed no variation with
baseline length, as expected if no weather contamination remained at a
significant level. Successive data files were then concatenated and maps were
made using a total of about 300 hours of good data.
Figure 1: 13.5-GHz map of the CAT1 field showing the difference between
orthogonal polarizations. The FWHM of the CAT primary beam is approximately
.
Figure 1 shows a map made by subtracting data recorded in linear orthogonal polarizations. The unpolarized components of the astronomical signals cancel. Polarized components would be expected to appear towards the centre of the map, in that region covered by the primary beam of the telescope. Radio sources are typically polarized at, or below, the few per cent level and the contribution from any polarized component of the CMBR is negligible. The rotation of the plane of polarization on the sky further reduces any unpolarized signal appearing on this map. The noise on the map is entirely consistent with the calculated instrumental noise given the system temperature of the telescope. (For a conversion between flux density sensitivity and sensitivity to brightness temperature on the sky see Hobson et al. (1995) and for its application to these data see Scott et al. (in preparation)). Figure 2 shows a map made by adding together data recorded in orthogonal linear polarizations.
Figure 2: 13.5-GHz map of the CAT1 field with orthogonal polarizations added.
The noise variance well away from the centre is the same as that on the
previous map, , but now astronomical signals appear in
that part of the map covered by the primary beam. The variance,
,
in this region of the map includes contributions from the instrumental noise
, radio sources
, the Galaxy
and the CMBR
. The variance
due to radio sources can conveniently be considered as the sum of the variance
due to sources with flux densities greater than 10 mJy,
, (the Ryle Telescope completeness limit,see below) and that due to
sources with a flux density less than 10 mJy,
, (which
give rise to confusion noise). The variance can be written as
After correction for the primary beam pattern it is found that in the field of view of the antennas.
Each candidate field was scanned using a raster technique with the Ryle
Telescope (RT; also at Cambridge) to produce a map of the central
region with a noise level of 2 mJy and a resolution
of
(Pooley, in preparation). Bright peripheral sources identified from
the 4.85-GHz survey were also observed with the RT to determine their flux
densities at 15.2 GHz. Flux densities at 1.4, 2.7, 5 and 10.7 GHz, where
available Kühr et al. (1981), along with the RT data, were used to determine the
source flux densities at 13.5 GHz. All sources brighter than 10 mJy in the
central
, and all other sources likely to contibute
10 mJy or more to the final map (taking into account the attenuation of the
primary beam away from the map centre) were subtracted. In all, it was found
necessary to subtract the visibilities of 31 sources from the measured
visibility. Figure 3 shows a simulated map showing what would have
been recorded had the CAT observed only these 31 radio sources in the absence of
any noise.
Figure 3: 13.5-GHz simulated noiseless map of the CAT1 field containing only
foreground (discrete) sources.
Figure 4: 13.5-GHz map of the CAT1 field with 31 sources subtracted.
Figure 4 shows the map made after source subtraction. Comparison
with Figure 1 reveals an excess variance
towards the centre of the map, given by
or
After correction for the primary beam it is found that . A source detection limit of 10 mJy gives
, so that
There is clear evidence for residual emission at 13.5 GHz consistent with reported levels of primordial anisotropy, but further measurements at different frequencies will be needed to separate the Galactic and CMBR components.
Preliminary tests have shown that the CAT is reaching its design sensitivity. During typical winter conditions 60 per cent of the data collected can be used. One candidate field (CAT1) has been observed at 13.5 GHz, with approximately 300 hours of data being used to make the final map. The Ryle Telescope has made raster scans at 15.2 GHz with sufficient sensitivity to subtract bright foreground radio sources, and after source subtraction the data show evidence for residual structure. The CMBR component of this anisotropy will be determined using future multi-frequency measurements.