Äîêóìåíò âçÿò èç êýøà ïîèñêîâîé ìàøèíû. Àäðåñ
îðèãèíàëüíîãî äîêóìåíòà
: http://www.atnf.csiro.au/vlbi/dokuwiki/doku.php/lbaops/observingnotes
Äàòà èçìåíåíèÿ: Unknown Äàòà èíäåêñèðîâàíèÿ: Sun Apr 10 23:55:30 2016 Êîäèðîâêà: IBM-866 Ïîèñêîâûå ñëîâà: ï ï ï ï ð ï ð ï ð ï ð ï ð ï ð ï ð ï ð ï ð ï ð ï |
To run a VLBI experiment, a number of independent programs need to be run. This include a program to control the telescope and IF setup, controlling the DAS and the LBADR disk recorder.
The DAS is controlled by a gui. Log onto the machine running the DAS control and run
> das1 & > das2 &
A gui is needed to control each DA individually. For each experiment determine which DAS profile is needed (the wiki guesses the profile, but this is not guaranteed to be correct).
FileòÆÒLoad
menu item, then selecting the correct profile in the file browser.Config Hwd
Start Monitor
Monitor IF Level
status bar. The this should be roughly mid range. If it goes of of range the DAS gui will complain and the attenuation (or catie gain at ATCA) will need to be adjusted.
The LBADR is a disk based recorder based around a standard PC. Data is recorded usually to external Xserve RAIDs, but can also be recorded to removable IDE disks or internal disks.
There is no need to shutdown the host PC to change Xraid disks. The following steps are needed to swap disks
> df | grep xraid
> umount /data/xraid0
(for example, do all mounted disks)
> mount /data/xraid0
etc
> /etc/init.d/recorder_server restart
Recording is make by a program called vsib_record
on the LBADR, which is controlled by a Tk gui cdisko
. Ssh as vlbi onto the LBADR recorder and run:
> cdisko
Fill in the following fields, based on the notes on the experiment wiki:
Scheduled start
button, click òÀÜNow + 10sòÀÝ then set the start time to the recording start time. If starting the recorder late, or when changing disk partition during an experiment do not use the scheduled start. start
buttonTo determine the correct channel selection, choose either 1-4 or 1-8 for 4 or 8 channel setups (as per the wiki). For other selections, the wiki should give the channel selection required.
The Xraid disks are òÀÜslicedòÀÝ into 2 or 3 sections (due to limits in the Linux kernel). The slices can record 6.5 hrs of data at 512 Mbps or 13 hrs at 256 Mbps. Normally record 6 (or 12) hours to a single slide. However always set the duration to be longer than the indented recording time in case you are late doing the change. If possible try and change disks during slew time.
To actually do a disk change, while recording
Scheduled start
is turned offStop
Start
The cdisko manual is at http://www-ra.phys.utas.edu.au/~jstevens/vsib/vsib_control_31.html
Default Recorder | DAS control | |
ATCA | cavsi1 | cavsi1 |
Mopra | mpvsi2 | mpvsi2 |
Parkes | pkvsi1 | pkvsi1 |