Документ взят из кэша поисковой машины. Адрес оригинального документа : http://www.atnf.csiro.au/pub/people/vlbi/vt10/vt10b2/sched.runlog Дата изменения: Sun Nov 19 11:41:26 2006 Дата индексирования: Thu Dec 27 18:32:51 2007 Кодировка: Поисковые слова: m 8

Welcome to program SCHED. Version: 6.02 July 2005

The manual is at http://www.aoc.nrao.edu/~cwalker/sched/sched/sched.html
Unix users should set $SCHED to the base area where SCHED is installed.
Most run time messages will be in sched.runlog

Some useful commands to give now if running interactively:
SCHedule= : Specify input file.
PLOT : Invokes uv, xy, rd, and uptime plotting.
FREQLIST=lowF,highF : Make frequency list (MHz). Then exit.
EXIT : Leave program.
/ : End of inputs - run program (or EXIT).

TPINI: Reading tape initialization information from SCHED input file.
SRREAD: Reading source catalog: Program_input
STREAD: Reading station catalog: /nfs/atapplic/vlbi/sched/catalogs/stations.dat
STREAD: Will read locations file /nfs/atapplic/vlbi/sched/catalogs/locations.dat
SCHIN: Found 201 input scans.
CHKCODE: EXPCODE = vt10b2

WRTMSG: Special message from routine CHKCODE:

======================================================================
WARNING The project code (EXPCODE) for this observation has a
non-standard format. Valid codes start with one or two
letters followed by 3 digits. Any leading zeros should
be included. A couple of valid examples are bt068
and v003.

Note that some SCHED examples use non-valid codes, as do
VLBA test observations.
======================================================================


SRREAD: Reading source catalog: /nfs/atapplic/vlbi/sched/catalogs/sources.vlba
RDSET: Reading setup file: /nfs/atapplic/vlbi/sched/setups/lba18cm-2p-1IF.set
GETFREQ: Reading frequency file: /nfs/atapplic/vlbi/sched/catalogs/freq.dat
SHORTN: WARNING - Source names longer than 8 characters used.
Mark III correlators and geodetic software will have problems.
SCHOPT: First output scan will be number 1
SCHOPT: There will be 201 output scans ( 1 - 201) from 323/10:00:00 to 323/21:01:00
SUMOPE: Writing summary file vt10b2.sum
OMSOUT: Writing OMS file vt10b2.oms
VXWRT : Writing V E X file vt10b2.skd
VXWRIF: WARNING, Phase cal not under computer control for some stations.
Contact stations by e-mail to make sure phase cal is switched off
VXS2MD: S2 Modes with DAR = NONE wiring not implemented, using naive S2 mode
VXWRTR: WARNING, un-documented S2_data_source, may not be recognized by PCFS
FLAGS: Writing apriori flagging file vt10b2.flag
Processing PARKES
Processing ATCA
Processing MOPRA
Processing HOBART