Документ взят из кэша поисковой машины. Адрес оригинального документа : http://www.atnf.csiro.au/pub/people/vlbi/vt07/vt07a2/sched.runlog Дата изменения: Thu Mar 9 09:40:31 2006 Дата индексирования: Thu Dec 27 18:22:02 2007 Кодировка:

Welcome to program SCHED. Version: 6.02 July 2005

The manual is at http://www.aoc.nrao.edu/~cwalker/sched/sched/sched.html
Unix users should set $SCHED to the base area where SCHED is installed.
Most run time messages will be in sched.runlog

Some useful commands to give now if running interactively:
SCHedule= : Specify input file.
PLOT : Invokes uv, xy, rd, and uptime plotting.
FREQLIST=lowF,highF : Make frequency list (MHz). Then exit.
EXIT : Leave program.
/ : End of inputs - run program (or EXIT).

TPINI: Reading tape initialization information from SCHED input file.
RDSET: Reading setup file: dual16pol.set
RDSET: Reading setup file: two16if.set
RDSET: Reading setup file: dualpoloffset.set
RDSET: Reading setup file: dualpolinverted.set
STREAD: Reading station catalog: /nfs/atapplic/vlbi/sched/catalogs/stations.dat
STREAD: Will read locations file /nfs/atapplic/vlbi/sched/catalogs/locations.dat
SCHIN: Found 15 input scans.
CHKCODE: EXPCODE = vt07a2

WRTMSG: Special message from routine CHKCODE:

======================================================================
WARNING The project code (EXPCODE) for this observation has a
non-standard format. Valid codes start with one or two
letters followed by 3 digits. Any leading zeros should
be included. A couple of valid examples are bt068
and v003.

Note that some SCHED examples use non-valid codes, as do
VLBA test observations.
======================================================================


SRREAD: Reading source catalog: /nfs/atapplic/vlbi/sched/catalogs/sources.vlba
GETFREQ: Reading frequency file: /nfs/atapplic/vlbi/sched/catalogs/freq.dat
SCHOPT: First output scan will be number 1
SCHOPT: There will be 15 output scans ( 1 - 15) from 68/07:00:00 to 68/12:14:00
SUMOPE: Writing summary file vt07a2.sum
OMSOUT: Writing OMS file vt07a2.oms
VXWRT : Writing V E X file vt07a2.skd
VXWRIF: WARNING, Phase cal not under computer control for some stations.
Contact stations by e-mail to make sure phase cal is switched off
VXS2MD: S2 Modes with DAR = NONE wiring not implemented, using naive S2 mode
VXWRTR: WARNING, un-documented S2_data_source, may not be recognized by PCFS
VXSCH: Tsys calibration is taken during every gap in recording, but these appear over 15 min apart!
This can be improved by inserting 40 second gaps at regular intervals.
FLAGS: Writing apriori flagging file vt07a2.flag
Processing ATCA
Processing MOPRA
Processing PARKES
Processing CEDUNA