Документ взят из кэша поисковой машины. Адрес
оригинального документа
: http://www.arcetri.astro.it/irlab/doc/library/hwbook/connector/bus/isa.html
Дата изменения: Sat Jul 7 00:58:35 2001 Дата индексирования: Sat Dec 22 15:18:45 2007 Кодировка: Поисковые слова: manicouagan crater |
ISA=Industry Standard Architecture
(at the card)
(at the computer)
62+36 PIN EDGE CONNECTOR MALE at the card.
62+36 PIN EDGE CONNECTOR FEMALE at the computer.
Pin | Name | Dir | Description |
---|---|---|---|
A1 | /I/O CH CK | ![]() |
I/O channel check; active low=parity error |
A2 | D7 | ![]() |
Data bit 7 |
A3 | D6 | ![]() |
Data bit 6 |
A4 | D5 | ![]() |
Data bit 5 |
A5 | D4 | ![]() |
Data bit 4 |
A6 | D3 | ![]() |
Data bit 3 |
A7 | D2 | ![]() |
Data bit 2 |
A8 | D1 | ![]() |
Data bit 1 |
A9 | D0 | ![]() |
Data bit 0 |
A10 | I/O CH RDY | ![]() |
I/O Channel ready, pulled low to lengthen memory cycles |
A11 | AEN | ![]() |
Address enable; active high when DMA controls bus |
A12 | A19 | ![]() |
Address bit 19 |
A13 | A18 | ![]() |
Address bit 18 |
A14 | A17 | ![]() |
Address bit 17 |
A15 | A16 | ![]() |
Address bit 16 |
A16 | A15 | ![]() |
Address bit 15 |
A17 | A14 | ![]() |
Address bit 14 |
A18 | A13 | ![]() |
Address bit 13 |
A19 | A12 | ![]() |
Address bit 12 |
A20 | A11 | ![]() |
Address bit 11 |
A21 | A10 | ![]() |
Address bit 10 |
A22 | A9 | ![]() |
Address bit 9 |
A23 | A8 | ![]() |
Address bit 8 |
A24 | A7 | ![]() |
Address bit 7 |
A25 | A6 | ![]() |
Address bit 6 |
A26 | A5 | ![]() |
Address bit 5 |
A27 | A4 | ![]() |
Address bit 4 |
A28 | A3 | ![]() |
Address bit 3 |
A29 | A2 | ![]() |
Address bit 2 |
A30 | A1 | ![]() |
Address bit 1 |
A31 | A0 | ![]() |
Address bit 0 |
B1 | GND | Ground | |
B2 | RESET | ![]() |
Active high to reset or initialize system logic |
B3 | +5V | +5 VDC | |
B4 | IRQ2 | ![]() |
Interrupt Request 2 |
B5 | -5VDC | -5 VDC | |
B6 | DRQ2 | ![]() |
DMA Request 2 |
B7 | -12VDC | -12 VDC | |
B8 | /NOWS | ![]() |
No WaitState |
B9 | +12VDC | +12 VDC | |
B10 | GND | Ground | |
B11 | /SMEMW | ![]() |
System Memory Write |
B12 | /SMEMR | ![]() |
System Memory Read |
B13 | /IOW | ![]() |
I/O Write |
B14 | /IOR | ![]() |
I/O Read |
B15 | /DACK3 | ![]() |
DMA Acknowledge 3 |
B16 | DRQ3 | ![]() |
DMA Request 3 |
B17 | /DACK1 | ![]() |
DMA Acknowledge 1 |
B18 | DRQ1 | ![]() |
DMA Request 1 |
B19 | /REFRESH | ![]() |
Refresh |
B20 | CLOCK | ![]() |
System Clock (67 ns, 8-8.33 MHz, 50% duty cycle) |
B21 | IRQ7 | ![]() |
Interrupt Request 7 |
B22 | IRQ6 | ![]() |
Interrupt Request 6 |
B23 | IRQ5 | ![]() |
Interrupt Request 5 |
B24 | IRQ4 | ![]() |
Interrupt Request 4 |
B25 | IRQ3 | ![]() |
Interrupt Request 3 |
B26 | /DACK2 | ![]() |
DMA Acknowledge 2 |
B27 | T/C | ![]() |
Terminal count; pulses high when DMA term. count reached |
B28 | ALE | ![]() |
Address Latch Enable |
B29 | +5V | +5 VDC | |
B30 | OSC | ![]() |
High-speed Clock (70 ns, 14.31818 MHz, 50% duty cycle) |
B31 | GND | Ground | |
C1 | SBHE | ![]() |
System bus high enable (data available on SD8-15) |
C2 | LA23 | ![]() |
Address bit 23 |
C3 | LA22 | ![]() |
Address bit 22 |
C4 | LA21 | ![]() |
Address bit 21 |
C5 | LA20 | ![]() |
Address bit 20 |
C6 | LA18 | ![]() |
Address bit 19 |
C7 | LA17 | ![]() |
Address bit 18 |
C8 | LA16 | ![]() |
Address bit 17 |
C9 | /MEMR | ![]() |
Memory Read (Active on all memory read cycles) |
C10 | /MEMW | ![]() |
Memory Write (Active on all memory write cycles) |
C11 | SD08 | ![]() |
Data bit 8 |
C12 | SD09 | ![]() |
Data bit 9 |
C13 | SD10 | ![]() |
Data bit 10 |
C14 | SD11 | ![]() |
Data bit 11 |
C15 | SD12 | ![]() |
Data bit 12 |
C16 | SD13 | ![]() |
Data bit 13 |
C17 | SD14 | ![]() |
Data bit 14 |
C18 | SD15 | ![]() |
Data bit 15 |
D1 | /MEMCS16 | ![]() |
Memory 16-bit chip select (1 wait, 16-bit memory cycle) |
D2 | /IOCS16 | ![]() |
I/O 16-bit chip select (1 wait, 16-bit I/O cycle) |
D3 | IRQ10 | ![]() |
Interrupt Request 10 |
D4 | IRQ11 | ![]() |
Interrupt Request 11 |
D5 | IRQ12 | ![]() |
Interrupt Request 12 |
D6 | IRQ15 | ![]() |
Interrupt Request 15 |
D7 | IRQ14 | ![]() |
Interrupt Request 14 |
D8 | /DACK0 | ![]() |
DMA Acknowledge 0 |
D9 | DRQ0 | ![]() |
DMA Request 0 |
D10 | /DACK5 | ![]() |
DMA Acknowledge 5 |
D11 | DRQ5 | ![]() |
DMA Request 5 |
D12 | /DACK6 | ![]() |
DMA Acknowledge 6 |
D13 | DRQ6 | ![]() |
DMA Request 6 |
D14 | /DACK7 | ![]() |
DMA Acknowledge 7 |
D15 | DRQ7 | ![]() |
DMA Request 7 |
D16 | +5 V | ||
D17 | /MASTER | ![]() |
Used with DRQ to gain control of system |
D18 | GND | Ground |
Note: Direction is Motherboard relative ISA-Cards.
Note: B8 was /CARD SLCDTD on the XT. Card selected, activated by cards in XT's slot J8
Contributor: Joakim жgren, Rob Gill
Sources:
IBM PC/AT Technical Reference, pages 1-25 through 1-37
comp.sys.ibm.pc.hardware.* FAQ Part 4 - maintained by Ralph Valentino
Copyright © The Hardware Book Team 1996-2001.
May be copied and redistributed, partially or in whole, as appropriate.
Document last modified: 2001-06-07