Документ взят из кэша поисковой машины. Адрес
оригинального документа
: http://www.astronomy.net/forums/atm/messages/3654.shtml
Дата изменения: Unknown Дата индексирования: Sun Apr 10 00:49:26 2016 Кодировка: Поисковые слова: aldebaran |
![]() |
|
![]() |
||||
|
Tool Base Material?
Forum List | Follow Ups | Post Message | Back to Thread Topics Posted by Scott Ghiz on November 14, 2006 22:20:45 UTC |
Hi there. I've used Pour Stone in the past to make grinding and pitch lap tool bases. It was always a relatively drawn out process because the Pour Stone literally took days to fully cure and then it had to be sealed with epoxy which took another day or so to fully cure. The pour stone tools worked quite well, but I've read about dental stone and that it doesn't need to be sealed and it doesn't seem to take very long to set up.
|
|
Additional Information |
---|
![]() |
About Astronomy Net | Advertise on Astronomy Net | Contact & Comments | Privacy Policy |
Unless otherwise specified, web site content Copyright 1994-2016 John Huggins All Rights Reserved Forum posts are Copyright their authors as specified in the heading above the post. "dbHTML," "AstroGuide," "ASTRONOMY.NET" & "VA.NET" are trademarks of John Huggins |