|
Документ взят из кэша поисковой машины. Адрес
оригинального документа
: http://www.atnf.csiro.au/vlbi/wiki/index.php?n=LBASep2015.V490D
Дата изменения: Unknown Дата индексирования: Tue Apr 12 15:17:24 2016 Кодировка: Поисковые слова: п п п п п п п п п п п п п п п п п п |
V490Dv490d
Setup v490d.1cm-icrf: NIF=4
Setup v490d.1cm: NIF=2
Mode changes: Comments:Due to popular demand V490 has copied the basic strategy used for the V255 series of methanol maser astrometry experiments. There are two different frequency setups, the "ICRF" observations to calibrate the tropospheric delay has 2 IFs with different polarizations. The second setup (the one used for the majority of the time) has a single IF with dual polarisation. The times for the setup (mode) changes are given above. The purpose of these observations is to obtain the fourth epoch for proper motion observations of water masers in the SMC and LMC. Observing comments for each antenna:Hobart, Ceduna :The 4 x 16 MHz bandpass setup requires feeding two separate LOs into IFP#1 and #2 on the DAS/frequency translator. For both Hobart and Ceduna the LOs should be set to 706 MHz (IFP#1) and 206 MHz (IFP#2) for the 4 x 16 MHz setup and 495 MHz for the 2 x 16 MHz setup. For Hobart use 16.37 GHz as the Agilent frequency and for Ceduna use 17.47 GHz. For the 4x16 MHz setup 880.2 and 900.2 MHz should give coherence in IF#1 and IF#2 respectively, while for the 2x16 MHz use 888.64 MHz to check coherence (these tones apply for both Hobart and Ceduna). The level into IF#2 will change significantly between the two setups. Set the level into the DAS so that it is within range for both setups. Setup the system temperature measurement so that it works for both IFs for the v490d.1cm setup - it doesn't matter if the system temperature measurement doesn't work for the second IF during the ICRF observations as these are only to calibrate the delay. Please don't change the attenuation into the DAS when the setup changes as that may change the delay. Parkes, ATCA, Mopra :For the ATCA please phase-up antennas CA01 through CA05 for this experiment. The sources 0100-760, 0601-706 and 0530-727 should all be suitable for phasing the array (in addition to the fringe finder sources) and have been marked with the AUTOPHASE_DETERMINE intent in the vex file. The information below for Parkes has been copied from the v490b experiment and may need to be updated. Parkes LO can be controlled using the "losched" command. It assume the initial setup has been made usign a normal lo_setup file. Run if as pksobs on joffrey: > losched v490b.losetup
using Observing comments for each antenna:
Observing LogsATCA antenna summary WeatherATCA Weather Monica log information - EXPERIMENTAL: |